Kites and drones used to harness wind power could revolutionize renewable energy

High-altitude kites or drones could be used to harness dependable wind power and could revolutionize approaches to renewable energy generation, scientists believe.

A research team at the University of Madrid are using the giant aeroflot kites used in kite surfing to experiment with on-board energy generation, in the form of small wind-turbines mounted to the aircraft.

The power generated is then transmitted to the ground via a cable tether which also keeps the kite in place.

In comparison to expensive traditional wind-turbines, airborne wind energy systems (AWES) present low installation and material costs. They would also operate at high altitudes of over 500 metres, where they present a low visual impact and where winds are more intense and less intermittent.

The researchers said the technology’s easier transportation make them suitable for producing energy in remote and difficult access areas. Therefore they could be deployed to provide temporary power generation in remote areas or disaster zones.As well as having on-board generators, the team is also experimenting with a system in which the movements of the tether could generate power on the ground.

Gonzalo Sánchez Arriaga, a researcher at the university’s business school UC3M, said: “The ultimate aim is to produce clean energy.

“The main advantage of airborne energy systems is that they operate at higher altitudes than conventional aerogenerators where the winds tend to be stronger and less intermittent. Another advantage is they are usually more compact systems and they are transportable.”

He added: “We believe systems like these can be placed into a container and in the event of a catastrophe such as an earthquake or where energy needs to be generated in a specific place, where fuel cannot be supplied for example, these kinds of devices can be used.”

UC3M PhD student Ricardo Borobia Moreno, who is also an aerospace engineer at the Spanish National Institute of Aerospace Technology (Inta), said: “The aim of this simulation is to reproduce how these systems will behave in flight in order to predict as accurately as possible how much energy we can generate and its reliability and safety in flight.”

The team has presented a flight simulator for AWES in a scientific article published in Applied Mathematical Modelling.

“The simulator can be used to study the behavior of AWES, optimize their design and find the trajectories maximizing the generation of energy,” Mr Moreno said.

Two kite surf kites have been equipped with instruments to record information such as the position and speed of the kite, attack and side slip angles, and tether tensions. The experimental data collected was used to inform the creation of the software simulator.

“We gauge its position, the speed of the kite and the speed of the air. Characteristically with these systems which are tied to the ground with tethers, we measure the tension in the tethers to estimate the aerodynamic forces which are being generated by the kite,” Mr Moreno said.

Source:Independent

Post Author: Chido Luciasi

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.